Axis 950 Manuale Utente Scaricare il pdf (Pagina 10)

Section 2: Basic Installation

10 AXIS 850/950 User’s Manual



6. Connect power to the Axis CD-ROM server.

The CD-ROM

server indicators will flash during power-on and self-test. When

the STATUS indicator stops flashing and remains unlit, the CD-

ROM server is ready for use.

If you intend to connect more CD-ROM drives to the Axis 851 or

951 CD-ROM server, the internal SCSI termination of the CD-

ROM server has to be turned off. To do this, the CD-ROM server has

to be connected to the network and configured. Proceed with

“Connecting the Axis CD-ROM Server to the Network” on page 14

and then with sections 3, 4 and 5. After turning internal SCSI

termination off according to the instructions in section 5, return to

“Connecting CD-ROM drives to the Axis CD-ROM Server” below.

Connecting CD-ROM Drives to the Axis CD-ROM Server

Up to seven SCSI CD-ROM drives can be serviced by a single Axis

CD-ROM Server. The drives are connected using the appropriate

SCSI cable, which must be ordered separately.

Before you begin

• Make sure that the power supply is marked with the correct mains

voltage.

• Always make sure the power is not connected to the CD-ROM

server or any of the CD-ROM drives when making changes to the

SCSI chain.

• If you are using an AXIS 851 or AXIS 951 CD-ROM server with

an internal drive, make sure the internal termination is off. See

section 5.

1. Connect the SCSI cable to the external connector on the CD-

ROM server.

2. Connect the SCSI cable to the external drive.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 68 69

Nessun commento

Axis 950 Manuale Utente Pagina 10